Room Lamp Replacement

CAUTION:

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the room lamp cover (B).
After loosening the mounting screws, then remove the room lamp (A).

Fig 1: Room Lamp & Room Lamp Cover
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connector (A).

Fig 2: Room Lamp Connector
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
NOTE:
- Make sure the connectors are plugged in properly.