Repair Procedures: Replacement

Remove the rear wheel & tire.
Tightening Torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

CAUTION: Be careful not to damage to the hub bolts when removing the rear wheel & tire.
Loosen the nut and then remove the rear stabilizer link (B) with the rear lower arm (A).
Tightening Torque:

98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

Fig 1: Identifying Rear Stabilizer Link And Rear Lower Arm
Courtesy of HYUNDAI MOTOR CO.
Loosen the bolt & nut and then remove the rear lower arm (A) with the rear axle.
Tightening Torque:

137.3~156.9 N.m (14.0~16.0 kgf.m, 101.3~115.7 lb-ft)

Fig 2: Identifying Rear Lower Arm
Courtesy of HYUNDAI MOTOR CO.
Loosen the bolt & nut and then remove the rear lower arm (B) with the sub frame (A).
Tightening Torque:

107.9~117.7 N.m (11.0~12.0 kgf.m, 79.6~86.8 lb-ft)

Fig 3: Identifying Rear Lower Arm And Sub Frame
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
Check the alignment. (Refer to ' ALIGNMENT ')