Repair Procedures: Replacement

Remove the rear wheel & tire.
Tightening Torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

CAUTION: Be careful not to damage to the hub bolts when removing the rear wheel & tire.
Remove the split pin and castle nut and then disconnect the rear assist arm (A) from the rear axle.
Tightening Torque:

78.5 ~ 88.3 N.m (8.0 ~ 9.0 kgf.m, 57.9 ~ 65.1 lb-ft)

Fig 1: Identifying Rear Assist Arm
Courtesy of HYUNDAI MOTOR CO.
Loosen the bolt & nut and then remove the rear assist arm (A) with the sub frame.
Tightening Torque:

107.9 ~ 117.7 N.m (11.0 ~ 12.0 kgf.m, 79.6 ~ 86.8 lb-ft)

Fig 2: Identifying Rear Assist Arm
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
Check the alignment.
(Refer to ' ALIGNMENT ')