Component Inspection
- Ignition "ON" & Engine "OFF" and Using a scan tool, clear the DTC.
- Ignition "OFF".
- Disconnect the battery (-) terminal cable from the battery, and wait at least one minute.
- Disconnect WCS sensor connector.
- Substitute the WCS sensor or WCS Module and check for proper operation. (COMMENT: WHY ARE THERE TWO SUBSTITUTION OF WCS SENSOR/MODULE. ONE IN STEP #5 AND ONE ARE NOTED BELOW?)
- Is DTC present problem?
YES
- Substitute a known-good SRSCM, and check for proper operation.
If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure and Go to "WCS RESET " procedure.
- Substitute the SRS main harness and check for proper operation.
If the problem is corrected, and replace SRS main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure and Go to "WCS RESET " procedure.
NO
- Substitute a known-good WCS Sensor or known-good seat assembly or WCS Module, and check for proper operation.
If the problem is corrected, replace WCS Sensor or seat assembly and Go to "WCS RESET " procedure.
- Substitute a known-good SRSCM, and check for proper operation.