LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2011 >> Sonata GLS, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels - Except HEV >> Rear Door >> Repair Procedures >> Replacement >> Glass Replacement

Glass Replacement

NOTE:
  • Put on gloves to protect your hands.
  1. Remove the rear door trim.
  2. Remove the rear door belt inside weatherstrip (A).
    Fig 1: Identifying Rear Door Belt Inside Weatherstrip
    G07359475Courtesy of HYUNDAI MOTOR CO.
  3. After loosening the mounting screws, then remove the delta outer cover (A).
    Fig 2: Identifying Delta Outer Cover
    G07359476Courtesy of HYUNDAI MOTOR CO.
  4. Release the rear channel mounting bolts and nut.
  5. Remove the glass mounting hole plug (A).
    NOTE:
    • Using the door switch to align the mounting hole with the hole on the door glass.
    • If it is impossible, align the hole by hand after removing the motor.
    • Be careful not to drop to glass and scratch the glass surface.
  6. Carefully move the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

    Tightening torque: 

    3.9 ~ 2.9 N.m (0.4 ~ 1.2 kgf.m, 11.8 ~ 8.7 lb-ft)

    Fig 3: Identifying Glass Mounting Hole Plug And Glass
    G07359477Courtesy of HYUNDAI MOTOR CO.
  7. Installation is the reverse of removal.
    NOTE:
    • Roll the glass up and down to see if it move freely without binding.
    • Adjust the glass position as needed.
scientia non olet · About LEMON Manuals