LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2011 >> Sonata GLS, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels - Except HEV >> Front Door >> Repair Procedures >> Replacements >> Glass Replacement

Glass Replacement

  1. Remove the front door trim.
  2. Remove the front door belt inside weatherstrip (A).
    Fig 1: Identifying Front Door Belt Inside Weatherstrip
    G07359454Courtesy of HYUNDAI MOTOR CO.
  3. Remove the glass mounting hole plug (A).
    NOTE:
    • Using the door switch to align the mounting hole with the hole on the door glass.
    • If it is impossible, align the hole by hand after removing the motor.
    • Be careful not to drop to glass and scratch the glass surface.
  4. Carefully adjust the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

    Tightening torque: 

    3.9 ~ 2.9 N.m (0.4 ~ 1.2 kgf.m, 11.8 ~ 8.7 lb-ft)

    Fig 2: Identifying Glass Mounting Hole Plug
    G07359455Courtesy of HYUNDAI MOTOR CO.
  5. Installation is the reverse of removal.
    NOTE:
    • Roll the glass up and down to see if it move freely without binding.
    • Adjust glass position as needed.