Trunk Lid Garnish Replacement

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
Put on gloves to protect your hands.
Take care not to scratch the body surface.

Remove the trunk lid trim.
(Refer to the - "TRUNK LID ")
After loosening the mounting nuts, then remove the rear combination lamp (A).

Fig 1: Identifying Rear Combination Lamp
Courtesy of HYUNDAI MOTOR CO.
Using a screwdriver or remover, remove the trunk lid garnish (A).

Fig 2: Identifying Trunk Lid Garnish
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connector (B).

Fig 3: Identifying Trunk Lid Garnish Connector
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
NOTE:
- Replace any damage clips.
- Make sure the trunk lid locks/unlocks and opens/closes properly.