Repair Procedures: Replacement

NOTE:

After remove the rear combination lamp.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
Put on gloves to protect your hands.
Take care not bend or scratch the cover and other parts.

Remove the following items.
1. Luggage cover mat
  (Refer to the "TRUNK TRIM ")
2. Transverse trim
  (Refer to the "TRUNK TRIM ")
3. Luggage side trim
  (Refer to the "TRUNK TRIM ")
Remove the rear combination lamp cover (A).

Fig 1: Identifying Rear Combination Lamp Cover
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connector (A), and then remove the rear combination lamp mounting nuts.
Remove the rear combination lamp.

Fig 2: Identifying Rear Combination Lamp Connector
Courtesy of HYUNDAI MOTOR CO.
After loosening the rear bumper side's mounting clip and screws, then disconnect the side's.

Fig 3: Locating Rear Bumper Side's Mounting Clip And Screws
Courtesy of HYUNDAI MOTOR CO.
Remove the mounting bolts.

Fig 4: Identifying Rear Bumper Mounting Bolts
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connector (A).

Fig 5: Identifying Rear Bumper Connector
Courtesy of HYUNDAI MOTOR CO.
Loosen the rear bumper cover mounting clips, and then remove the rear bumper cover (A).

Fig 6: Identifying Rear Bumper Cover
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
NOTE:
- Replace any damage clips.