LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2011 >> Sonata GLS, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seat & Power Seat - Except HEV >> Rear Seat >> Repair Procedures >> Replacement >> Seat Assembly Replacement

Seat Assembly Replacement

  1. After loosening the mounting bolts, then remove the rear seat assembly (A).

    Tightening torque: 

    44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.5 ~ 43.4 lb-ft)

    Fig 1: Identifying Rear Seat Assembly With Mounting Bolts
    G07359672Courtesy of HYUNDAI MOTOR CO.
  2. Disconnect the seat heater connectors (A).
    Fig 2: Identifying Seat Heater Connectors
    G07359673Courtesy of HYUNDAI MOTOR CO.
  3. Installation is the reverse of removal.
    NOTE: Seat mounting bolt and nut installation procedure.
    • Tighten temporarily in the order of nut and bolt on the front of recliner hinge installation part.
    • After completely tightening completely the bolt on the back of the recliner hinge installation part, tighten the bolt on the front of it completely.
    • Setting down the seat cushion, tighten the mounting bolt of the cushion frame hinge.
    • Check if reclining the seat and folding seat back operate smoothly.
scientia non olet · About LEMON Manuals