Seat Cushion Cover Replacement

Remove front seat assembly.
Remove the recliner cover.
Push the protector (A), and then seat cushion cover (C) from the frame (B).

Fig 1: Identifying Protector, Seat Cushion Cover And Frame
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connectors (A).

Fig 2: Identifying Seat Cushion Cover Connectors
Courtesy of HYUNDAI MOTOR CO.
After removing the hog ring clips (B) on the front of seat cushion and remove the seat cushion cover (A).
CAUTION:
- When removing the hog ring clip, remove the hog ring clip with pressing the wire not to separate the wire from the sponge.
  
  Fig 3: Identifying Seat Cushion Cover And Hog Ring Clips
  Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
NOTE:
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog ring clips (A).
- Replace the hog ring clips with new ones using special tool (C) (09880-4F000).
  
  Fig 4: Replacing Hog Ring Clips With Using Special Tool
  Courtesy of HYUNDAI MOTOR CO.
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts (passenger's) (Refer to AIRBAG )