Seat Assembly Replacement

Remove the seat assembly mounting cover.
After loosening the seat assembly mounting bolts, remove the seat assembly (A).
Tightening torque:

44.1 ~ 58.8N.m (4.5 ~ 6.0kgf.m, 32.5~43.4lb-ft)

Fig 1: Identifying Seat Assembly With Mounting Bolts
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connectors (A).
[Driver's]

Fig 2: Identifying Front Seat Connectors (Driver's)
Courtesy of HYUNDAI MOTOR CO.

[Passenger's]

Fig 3: Identifying Front Seat Connectors (Passenger's)
Courtesy of HYUNDAI MOTOR CO.
Installation is the reverse of removal.
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts (passenger's) (Refer to AIRBAG )
CAUTION:
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
- Set the into the most rearward position. Check then each slide is locked, and then Tighten the front mounting bolt temporarily.
- Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
- Set the seat into the most rearward position. Check the front mounting bolt completely.
- Check that the seat operates to and fro smoothy and the locking portion locks properly.