Monitor Scantool data

Monitor Scantool Data

1. Connect scantool to Data Link Connector (DLC)
2. Ignition "ON" & Engine "ON".
3. Turn the steering wheel to the left or right.
4. Monitor the "Steering Angle Sensor" parameters on the Scantool.




Fig 1) Test Condition : Ignition "ON" & Engine "ON".
Normal Data
5. Whenever steering wheel is turned, is the steering sensor's scantool data changed ?
YES
(1) Connect scantool to Data Link Connector (DLC).
(2) Ignition "ON" & Engine "ON".
(3) Keep the steering wheel in center position.
(4) Monitor the "STEERING ANGLE SNSR" parameters on the Scantool.

Specification : Approx. 0 DEG


(5) Is parameter displayed within specifications ?





NO
> Go to "Terminal and Connector Inspection" procedure.
6. Perform steering angle sensor calibration.
(1) Ignition "ON" & Engine "OFF".
(2) (3) Connect scantool to Data Link Connector (DLC).
(4) Go in Elec. Power Steering system.
(5) Perform ASP calibration. (figure 2).
(6) Go to "Component Inspection" Procedure.