LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Elantra L4-2.0L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Testing and Inspection >> Component Tests and General Diagnostics >> Throttle Position Sensor (TPS) >> Component Inspection

Component Inspection





Component Inspection

1. Connect a scantool on the Data Link Connector (DLC).
2. Start engine and check output voltages of TPS at C.T and W.O.T.

Specification:Refer to SPECIFICATION.


3. Turn ignition switch OFF and disconnect the scantool from the DLC.
4. Disconnect TPS connector and measure resistance between TPS terminals 2 and 3

Specification:Refer to SPECIFICATION.


scientia non olet · About LEMON Manuals