Trunk / Liftgate Switch: Service and Repair

POWER TAIL GATE SWITCH

REPLACEMENT

OVERHEAD CONSOLE SWITCH
1. Disconnect the negative (-) battery terminal.




2. Open the sunglass case cover from the overhead console then remove the 2 screws holding the overhead console (A). And then disconnect the connector (B).
3. Installation is the reverse of removal.

TAIL GATE SWITCH
1. Disconnect the negative (-) battery terminal.




2. Open the tail gate and remove the tail gate trim switch (A) using the appropriate trim tool. And then remove the connector (B).
3. Installation is the reverse of removal.