Installation
REAR STRUT ASSEMBLYINSTALLATION
1. Assembly the rubber bumper and the dust cover to the rear shock absorber, after pulling the rod of the rear shock absorber completely.
2. Install the two rear shock absorber mounting bolts (A).
Tightening torque 50 - 65 Nm (5.0 - 6.5 kgf-cm, 36.2 - 47.0 ft. lbs.)
3. Install the shock absorber assembly (A) to the rear axle assembly (B) with the specified torque.
Tightening torque 140 - 160 Nm (14 - 16 kgf-cm, 101.2 - 115.7 ft. lbs.)
4. Install the wheel and the tire to the rear hub.
Tightening torque 90 - 110 Nm (9 - 11 kgf-cm, 65.1 - 79.5 ft. lbs.)
CAUTION: Be careful not to damage the hub bolts when installing the rear wheel and tire.