Engine Coolant Hose/Pipes: Reassembly
WARNING: This page is about a different variant/trim than selected.
Fit the O-ring in the groove of the engine coolant inlet pipe end. Wet the periphery of the O-ring with water and insert the engine coolant inlet pipe.
NOTE:
- Do not apply oil or grease to the engine coolant pipe O-ring.
- Keep the engine coolant pipe connections free of sand, dust, etc.
- Insert the engine coolant pipe into the end of the engine coolant pump inlet.
- Whenever installing the engine coolant inlet pipe, always replace the O-ring with a new one.