Accelerator Pedal: Installation

WARNING: This page is about a different variant/trim than selected.

When installing the return spring and accelerator arm, apply multi-purpose grease around each moving point of the accelerator arm.
Apply sealant to the bolt mounting hole and tighten the accelerator arm bracket.
Tightening torque

Accelerator arm bracket bolts:

8~12 Nm (80~120 kg.cm, 6~7 lb.ft)

Fig 1: Identifying Accelerator Cable & Arm
Courtesy of HYUNDAI MOTOR CO.
Securely install the resin bushing of the accelerator cable on the end of the accelerator arm.