LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2003 >> Santa Fe Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (2.7L V6 Engine) >> Timing System >> Timing Belt >> How To Adjust The Tension Of The Timing Belt

How To Adjust The Tension Of The Timing Belt

WARNING: This page is about a different variant/trim than selected.
  1. Rotate the crankshaft 2 turns clockwise and measure the projected length of the auto tensioner at TDC (# 1 Compression stroke) after 5 minutes.
  2. The projected length should be 7 ~ 9 mm (0.27 ~ 0.31 in.).
  3. Verify that the timing marks of each sprocket are in their specified position.
    NOTE: If the timing marks are not in their specified position, repeat from 6 above.
    Fig 1: Identifying Projected Length
    G00790372Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals