LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2003 >> Santa Fe Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (2.7L V6 Engine) >> Lubrication System >> Oil Pump >> Disassembly

Oil Pump: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil pressure switch, using 24 mm deep socket.
    NOTE: Since a sealant is used on the threaded area, be careful not to damage the oil pressure switch.
  2. Remove the oil filter and the oil pan.
  3. Remove the oil screen and gasket.
  4. Remove the three bracket securing bolts and remove the oil filter bracket and gasket.
  5. Remove the oil relief valve plug from the oil pump case.
  6. Remove the oil pump case.
    Fig 1: Removing Oil Pressure Switch
    G00790290Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals