LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2003 >> Santa Fe Base, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Component Tests >> Proportioning Valve

Proportioning Valve

  1. Remove the proportioning valve from the master cylinder.
  2. There are two pressure gauges. Connect one to the input side of the proportioning valve and the other to the output side of it.
    NOTE: Be sure to bleed the system after connecting the pressure gauges.
  3. With the brakes applied, measure the input pressure and the output pressure. If the measured pressures are within the specified range as illustrated, the proportioning valve is good. See Fig 1 .
  4. Reconnect the brake lines in their original positions and bleed the system. See BLEEDING BRAKE SYSTEM  .
Fig 1: Proportioning Valve Pressure Chart
G00306360Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals