Front & Rear Disc Brake Caliper: Reassembly

1. Apply brake caliper lubricant onto piston seal and install piston seal into caliper bore groove. Apply caliper lube to piston, cylinder bore and inside dust boot. Install dust boot onto piston.
2. Position piston with boot into caliper bore, and install dust boot lip into cylinder groove. Press piston into caliper bore, ensuring boot remains in groove. Apply brake caliper lube or rubber grease onto guide sleeve and inner portion of sleeve boots, and install caliper. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS .

Fig 1: Exploded View Of Front Disc Brake Caliper (Accent)

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Exploded View Of Front Disc Brake Caliper (Santa Fe)

Courtesy of HYUNDAI MOTOR CO.

Fig 3: Exploded View Of Front Disc Brake Caliper (Sonata & XG300 Shown; Elantra & Tiburon Are Similar)

Courtesy of HYUNDAI MOTOR CO.

Fig 4: Exploded View Of Rear Disc Brake Caliper (Elantra, Sonata & Tiburon; Santa Fe Is Similar)

Courtesy of HYUNDAI MOTOR CO.

Fig 5: Exploded View Of Rear Disc Brake (XG300)

Courtesy of GENERAL MOTORS CORP.