Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Tiburon Automatic, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,Both Axles,w/Rear Disc Brakes | 1.8 | B | ||
| All,Both Axles,w/Rear Drum Brakes | 2.2 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides,w/Disc Brakes | 1.0 | B | ||
| Rear,Both Sides,w/Drum Brakes | 1.4 | B | ||
| Combination Procedure: CALIPER: Overhaul: Includes: Bleed System. | ||||
| One,w/ABS | 0.7 | B | ||
| One,w/o ABS | 0.5 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed System. | ||||
| One,w/ABS | 0.5 | B | ||
| One,w/o ABS | 0.3 | B | ||
| Combination Procedure: WHEEL BEARING: Repack: | ||||
| Rear,Disc Brakes,Both Sides | 0.4 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: Includes: Repack Bearings (where applicable). | ||||
| Rear,Disc Brake,One Side | 0.3 | B | ||
| Rear,Drum Brake,One Side | 0.1 | B | ||