Rear (Accent, Elantra Wagon & Tiburon)

Disconnect rear wiper/washer switch harness connector. Check continuity in each switch position, between indicated switch terminals. See REAR WIPER/WASHER SWITCH CONTINUITY TEST table. See Fig 1-Fig 2 . If continuity does not exist, replace rear wiper/washer switch.

REAR WIPER/WASHER SWITCH CONTINUITY TEST

Switch Position

Continuity Between Terminals No.

Accent ⁽¹⁾

Wiper Switch On

4 & 9

Wiper Switch Intermittent On

4 & 6

Washer On

4 & 10

Elantra Wagon & Tiburon ⁽²⁾

Wiper/Washer Off

7 & 9

Wiper On/Washer Off

7 & 8

Washer On

6, 7 & 8

⁽¹⁾	Terminals No. 1 and 2 are for illumination circuit and should always have continuity.

⁽²⁾	Terminals No. 5 and 10 are for illumination circuit and should always have continuity.

Fig 1: Identifying Rear Wiper/Washer Switch Terminals (Accent)

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying Rear Wiper/Washer Switch Terminals (Elantra Wagon & Tiburon)

Courtesy of HYUNDAI MOTOR CO.