LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2000 >> Sonata Base, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1349, B1355, B1364, B1370, B1381, B1385, B1402, B1405: Component Short To Ground >> Check Passenger-side Side Impact AIR Bag Squib Circuit

Check Passenger-side Side Impact AIR Bag Squib Circuit

  1. Connect SRSCM harness to SRSCM. Turn ignition switch to ON position. Measure voltage between ground and terminal No. 25 (Black/White wire) on harness side of SRSCM. If voltage is zero, go to next step. If voltage is not zero, replace harness or connector between passenger-side side impact bag module and SRSCM.
  2. Ensure ignition switch is in LOCK position. Disconnect negative battery cable. Wait at least 30 seconds. Connect passenger-side side impact air bag module to harness connector. Connect negative battery cable. Wait 30 seconds. Turn ignition switch to ON position. Wait 30 seconds. Clear DTC"s in scan tool. Turn ignition switch to LOCK position.
    NOTE: DTCs other than 1385 may be recorded in scan tool. They are not relevant to this check and should be disregarded.
  3. Turn ignition switch to ON position. Wait 30 seconds. Check for DTC"s in scan tool. If DTC 1385 is recorded in scan tool, replace passenger-side side impact air bag module. If DTC 1385 is not recorded, system is functioning normally.
scientia non olet · About LEMON Manuals