LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2000 >> Sonata Base, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1349, B1355, B1364, B1370, B1381, B1385, B1402, B1405: Component Short To Ground >> Check Driver-side Seat Belt Pretensioner Squib Circuit

Check Driver-side Seat Belt Pretensioner Squib Circuit

  1. Ensure ignition switch is in LOCK position. Connect driver-side seat belt pretensioner electrical connector. Connect SRSCM harness connector to SRSCM. Connect negative battery cable. Wait 30 seconds. Turn ignition switch to ON position. Wait 30 seconds. Clear DTC"s in scan tool. Turn ignition switch to LOCK position. Wait 30 seconds.
    NOTE: DTCs other than B1364 may be recorded in scan tool memory. They are not relevant to this check and should be disregarded.
  2. Turn ignition switch to ON position. Wait 30 seconds. Check scan tool for DTC"s. If DTC B1364 is recorded in scan tool memory, replace driver-side seat belt pretensioner. If DTC B1364 is not recorded, system is functioning normally.
scientia non olet · About LEMON Manuals