Check Driver-side Satellite Sensor Circuit
- Ensure ignition switch is in LOCK position. Connect driver-side satellite electrical connector. Connect SRSCM harness connector to SRSCM. Connect negative battery cable. Wait 30 seconds.
- Turn ignition switch to ON position. Wait 30 seconds. Clear DTC"s in scan tool. Turn ignition switch to LOCK position. Wait 30 seconds.NOTE: DTCs other than 1402 may be recorded in scan tool. They are not relevant to this check and should be disregarded.
- Turn ignition switch to ON position. Wait 30 seconds. Check for DTC"s in scan tool. If DTC B1402 is recorded, replace driver-side satellite sensor. If DTC B1402 is not recorded, system is functioning normally.