LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2000 >> Sonata Base, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1348, B1354, B1363, B1369, B1380, B1384, B1401, B1404: Component Short To Ground >> Check Passenger-side Side Impact AIR Bag Squib Circuit

Check Passenger-side Side Impact AIR Bag Squib Circuit

  1. Measure resistance between ground and terminal No. 25 (Black/White wire) on SRSCM wire side of harness connector. See Figure. If resistance is infinite, go to next step. If resistance is not infinite, replace harness or connector between passenger-side side impact air bag module and SRSCM.
  2. Ensure ignition switch is in LOCK position. Connect passenger-side side impact air bag connector. Connect negative battery cable. Wait 30 seconds. Turn ignition switch to ON position. Wait 30 seconds. Clear any DTC"s in scan tool memory. Turn ignition switch to LOCK position. Wait 30 seconds.
    NOTE: DTC"s other than B1384 may be recorded in scan tool. They are not relevant to this test.
  3. Turn ignition switch to ON position. Wait 30 seconds. Check scan tool for DTC"s. If DTC B1384 is recorded, replace passenger-side side impact air bag module. If DTC B1384 is not recorded, system is functioning normally.
scientia non olet · About LEMON Manuals