LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2000 >> Sonata Base, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1348, B1354, B1363, B1369, B1380, B1384, B1401, B1404: Component Short To Ground >> Check Passenger-side Seat Belt Pretensioner Squib Circuit

Check Passenger-side Seat Belt Pretensioner Squib Circuit

  1. On models with passenger-side air bag, measure resistance between ground and terminal No. 9 (Light Green) on SRSCM harness side connector. On models without passenger-side air bag, measure resistance between ground and terminal No. 24 (Light Green) on SRSCM harness side connector. See Figure or Figure . If resistance is infinite, go to next step. If resistance is not infinite, replace harness or connector between passenger-side seat belt pretensioner and SRSCM.
  2. Ensure ignition switch is in LOCK position. Connect driver-side seat belt pretensioner connector. Connect negative battery cable. Wait 30 seconds. Turn ignition switch to ON position. Wait 30 seconds. Clear any DTC"s in scan tool memory. Turn ignition switch to LOCK position. Wait 30 seconds.
    NOTE: DTC"s other than B1369 may be recorded in scan tool. They are not relevant to this test.
  3. Turn ignition switch to ON position. Wait 30 seconds. Check scan tool for DTC"s. If DTC B1369 is recorded in scan tool, replace driver-side seat belt pretensioner. If DTC 1369 is not recorded, system is functioning normally.
scientia non olet · About LEMON Manuals