LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2000 >> Sonata Base, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Diagnostic Tests >> DTC B1348, B1354, B1363, B1369, B1380, B1384, B1401, B1404: Component Short To Ground >> Check Driver-side AIR Bag Squib Circuit

Check Driver-side AIR Bag Squib Circuit

  1. Measure resistance between ground and Green wire (driver-side initiator) on clockspring side of upper clockspring connector. See Figure or Figure . If resistance is infinite, go to next step. If resistance is not infinite, go to step  3.
  2. Disconnect connector between SRSCM and clockspring. Measure resistance between terminal No. 2 (Green wire) and ground. See Figure or Figure . If resistance is infinite, replace clockspring. If resistance is not infinite, replace wire harness between clockspring and SRSCM.
  3. Ensure ignition switch is in LOCK position. Connect driver-side air bag module electrical connector. Connect negative battery cable and wait at least 30 seconds. Turn ignition switch to ON position and wait at least 30 seconds. Clear DTC"s from scan tool. Turn ignition switch to LOCK position and wait 30 seconds.
    NOTE: DTC"s other than B1348 may be recorded in scan tool. They are not relevant to this test.
  4. Turn ignition switch to ON position. Wait 30 seconds. Check for DTC"s in scan tool. If DTC B1348 is in scan tool memory, replace driver-side air bag module. If DTC B1348 is not in scan tool memory, system is functioning normally.
scientia non olet · About LEMON Manuals