Hazard Warning Switch

Disconnect negative battery cable. Remove hazard switch. Disconnect hazard switch harness connector. Using an ohmmeter, check continuity in each switch position, between indicated switch terminals. See Fig 1-Fig 2. See HAZARD WARNING SWITCH TEST table. Replace switch if continuity is not as specified.

HAZARD WARNING SWITCH TEST

Application & Switch Position

⁽¹⁾ Check Continuity Between Terminals No.

Accent

Off

2 & 3; 5 & 8

2 & 3; 6, 9 & 10; 7 & 8

Except Accent

Off

2 & 3; 7 & 10

2 & 3; 5, 6 & 9; 7 & 8

⁽¹⁾	Terminals No. 2 and 3 are for illumination circuit.

Fig 1: Identifying Hazard Switch Harness Connector Terminals (Accent)

Courtesy of HYUNDAI MOTOR CO.

Fig 2: Identifying Hazard Switch Harness Connector Terminals (Except Accent)

Courtesy of HYUNDAI MOTOR CO.