Disc Rotor: Remove & Replace
WARNING: This page is about the Sonata Base, Automatic, which is a different variant/trim than selected.
Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front,Non Separable,Both | 3.4 | B | ||
| Front,Non Separable,One Side | 1.8 | B | ||
| Front,Separable,Inboard Mtd,Both | 3.4 | B | ||
| Front,Separable,Inboard Mtd,One Side | 1.8 | B | ||
| Front,Separable,Outboard Mounted,Both | 1.0 | B | ||
| Front,Separable,Outboard Mounted,One Side | 0.6 | B | ||
| Rear,Both | 1.4 | B | ||
| Rear,One Side | 0.8 | B | ||
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||