LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 1991 >> Excel GS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis & Overhaul - Km175, Km176 & Km177 >> Component Tests >> Pressure Control Solenoid Valve

Pressure Control Solenoid Valve

  1. Using ohmmeter, check resistance between solenoid valve terminal No. 2 and transaxle case. See Figure . Resistance should be 2.6-3.2 ohms. If resistance is not as specified, check for short circuit, damaged or disconnected wire. If wire is okay, replace Pressure Control Solenoid Valve (PCSV).
  2. Connect 12 volts to terminal No. 2 of solenoid valve. Ensure transaxle case is grounded. Listen for clicking noise when voltage is applied and removed. If clicking noise is heard, valve is operating. If clicking noise is not heard, check for foreign material caught between valve and valve guide. If foreign material is not found, replace PCSV.
scientia non olet · About LEMON Manuals