LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 1991 >> Excel GS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis & Overhaul - Km175, Km176 & Km177 >> Component Tests >> Inhibitor Switch

Inhibitor Switch

  1. Using ohmmeter, with selector lever in "P" position, ensure continuity exists between terminals No. 3 and 4, and between terminals No. 10 and 11. See Fig 1 . With selector lever in "R" position, ensure continuity exists between terminals No. 3 and 12, and between, terminals No. 8 and 9.
  2. With selector lever in "N" position, ensure continuity exists between terminals No. 3 and 5, and between terminals No. 10 and 11. With selector lever in "D" position, ensure continuity exists between terminals No. 1 and 3.
  3. With selector lever in "2" position, ensure continuity exists between terminals No. 3 and 6. With selector lever in "L" position, ensure continuity exists between terminals No. 2 and 3.
  4. If, continuity is as specified, inhibitor switch is okay. If continuity is not as specified, check for poor connection, damaged or disconnected wire. If wire is okay, replace inhibitor switch.
Fig 1: Identifying Inhibitor Switch Connector Terminals
G95G20285Courtesy of HYUNDAI MOTOR CO.
scientia non olet · About LEMON Manuals