Rear Wiper & Washer Switch

Remove rear wiper/washer switch instrument panel. Using an ohmmeter check for continuity between terminals of connector in each switch position.
Ensure wire leads are not being pulled while moving switch from one position to another. Note terminal identification. SeeFig 1 . Check switch continuity. See REAR WIPER SWITCH CONTINUITY TEST table.

Fig 1: Rear Wiper Switch Terminal Identification

Courtesy of HYUNDAI MOTOR CO.

REAR WIPER SWITCH CONTINUITY TEST

Switch Position	Terminals	Continuity
On	A & B	Yes
Off	B & C	Yes