LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2010 >> H3 Alpha >> Repair and Diagnosis >> External Pages >> Different car >> Section 1210 (Anti-Lock Brake System - Non-Hybrid Greater Than/Equal To 3900 Kg (8600 Lb) GVW With TCS & VES) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL and 2008 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Wheel Speed Sensor
    GM924313Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the electrical connector.
  3. Remove the wheel speed sensor retaining bolt.
  4. Release the wheel speed sensor wiring harness from the retainers.
  5. Remove the wheel speed sensor.
scientia non olet · About LEMON Manuals