Rear Seat Frame Front Finish Cover Replacement (HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Frame Front Finish Cover (HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Turn the ignition switch to the off/lock position, remove the ignition key and secure in technicians pocket until procedure is complete. Flip and fold the rear seat forward.
1	Rear Seat Frame Outer Finish Cover Procedure: Pull upward to disengage the retainer clips.
2	Rear Seat Riser Finish Cover Pull upward to disengage the retainer clips For reinstallation use the 3 locators to align part properly Engage upper and lower front clips to the back edge of rear seat frame front finish cover. To finish installation process move rearward along the cover. Part is properly installed when all edges are aligned with rear seat frame front finish cover.
3	Rear Seat Frame Front Finish Cover Procedure Fold the rear seat down and latch in place to access the finish cover. Pull forward to disengage the retainer clips.