LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H3T Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel Displays And Gages >> Diagnostic Information and Procedures >> Chime Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the ignition switch.
  2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 2 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ignition circuit fuse is open, test the signal circuit terminal 4 for a short to ground.
  3. Verify the scan tool Ign. Off/Run/Crank parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 4 for a short to voltage. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the signal circuit terminal 4 and the B+ circuit terminal 2. Verify the scan tool Ign. Off/Run/Crank parameter is Active.
    • If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the ignition switch.
scientia non olet · About LEMON Manuals