LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H3 Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel Displays And Gages >> Diagnostic Information and Procedures >> DTC P0463 >> Circuit/System Testing

Circuit/System Testing

NOTE: If equipped, the following tests can be performed at an inline connector. See schematics for the corresponding terminals to test at.
  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition OFF, test for less than 1 Ω between the low reference circuit terminal C and ground.
    • If greater than the specified range, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, install a 3 A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal C. Verify the scan tool Fuel Tank Level Remaining or the Fuel Level Sensor parameter display is greater than 98 percent.
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the fuel level sensor.
scientia non olet · About LEMON Manuals