Transmission Output Shaft Seal Replacement

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the propeller shaft. Refer to Rear Propeller Shaft Replacement .
3. Support the transmission with a suitable jack.
4. Remove the transmission mount assembly. Refer to Transmission Mount Replacement .
5. Remove the transfer case adapter. Refer to Transfer Case Adapter Replacement .

• Use the J 45000  Seal Remover, to remove the seal. See Special Tools . Use care in order to avoid damaging the output shaft bushing.
• Lubricate the seal with clean transmission fluid.
• Use the J 36183  Seal Installer, to install the seal.