LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2009 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6L80 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> On-Vehicle Repair Instructions >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

  1. Position the transmission shift control lever to the park position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Ensure the transmission range selector lever is positioned to mechanical park.
    4. Fig 1: Identifying Range Selector Cable Components
    GM1971076Courtesy of GENERAL MOTORS CORP.
  4. Remove the range selector cable retaining clip (2).
  5. Remove the range selector cable (3) from the range selector cable bracket (1) at the transmission.
  6. Remove the range selector cable (3) from the transmission range selector lever ball stud (4).
  7. Lower the vehicle and ensure that the shift lever is still in the park position.
    8. Fig 2: Identifying Range Selector Cable & End
    GM1967928Courtesy of GENERAL MOTORS CORP.
  8. Remove the console. Refer to Front Floor Console Replacement .
  9. Remove the range selector cable end (2) from the transmission shift control lever ball stud.
  10. Remove the range selector cable (1) from the transmission shift control lever housing.
    11. Fig 3: Identifying Range Selector Cable Grommet
    GM1971151Courtesy of GENERAL MOTORS CORP.
  11. Remove the range selector cable grommet (1) from the floor panel.
  12. Remove the range selector cable from the vehicle.
scientia non olet · About LEMON Manuals