Torque Converter Housing with Fluid Pump Installation
| Callout | Component Name |
|---|---|
| 1 | NEW Fluid Pump Seal |
| 2 | Torque Converter (with Fluid Pump) Housing Assembly
CAUTION:
Ensure the turbine shaft (O-ring) seal is not installed prior to installing the torque converter housing assembly. The seal may become cut or damaged during installation of the torque converter housing assembly.
|
| 3 | Bolts M10 x 50 (Qty: 9)
CAUTION:
Refer to Fastener Caution
. Procedure: Tighten in the sequence shown. Tighten: 72 N.m (53 lb ft) |
| 4 | NEW Turbine Shaft (O-Ring) Seal |