Control Valve Body Assembly Installation
| Callout | Component Name |
|---|---|
| 1 | NEW Fluid Pump Seal Assembly |
| 2 | NEW Fluid Pump Seal Assembly |
| 3 | NEW Center Support Fluid Passage Seal Assembly |
| 4 | Control Valve Body Assembly Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin. |
| 5 | Bolts M5 x 73 (Qty: 6)
CAUTION:
Refer to Fastener Caution
. Procedure: Tighten in the sequence shown. Tighten: 8 N.m (71 lb in). Special Tool: DT-48285 Valve Body Torx Plus Socket (if applicable). See Special Tools . |