Upper to Lower Control Valve Body Assembly Assemble
| Callout | Component Name |
|---|---|
| 1 | Control Valve Body Ball Check Valve (Qty: 7)
CAUTION:
Do not use any type of grease or other material to hold the check ball valves in place during assembly. Grease will cause the valves to not operate properly, resulting in damage to the transmission. Tip: Refer to Ball Check Valve Locations . |
| 2 | Control Valve Body Spacer (w/Gasket) Plate Assembly
CAUTION:
Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.
|
| 3 | Control Valve Lower Body Assembly Tip: Turn the valve body assembly over after installing to upper body. |
| 4 | Bolt M5 x 36 (Qty: 12)
CAUTION:
Refer to Fastener Caution
. Procedure: Tighten the bolts in the sequence shown. Tighten: 8 N.m (71 lb in). |