1-2-3-4 and 3-5 Reverse Clutch Bearing Assembly Replacement

Fig 1: Identifying 1-2-3-4 & 3-5 Reverse Clutch Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	3-5 Reverse Clutch Bearing CAUTION: Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission. CAUTION: Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission. Specification: Install the bearing flush to 0.3 mm below the thrust surface. Special Tools DT 47865 Bearing Remover. See Special Tools . DT 47866 Bearing Installer. See Special Tools . J 8092 Driver Handle J 45124 Removal Bridge. See Special Tools .

Callout

Component Name

3-5 Reverse Clutch Bearing

CAUTION: Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission.

CAUTION: Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission.

Specification: Install the bearing flush to 0.3 mm below the thrust surface.

Special Tools