LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 285 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement (5.3L) >> Cable Removal - Shift Control End

Cable Removal - Shift Control End

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cable & Gromet
    GM2007270Courtesy of GENERAL MOTORS CORP.
  1. Push the cable grommet (2) and cable (1) up through the floor panel.
  2. Lower the vehicle.
  3. Remove the left hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side .
  4. Pull the drivers side carpet up, enough to access the range selector cable.
    5. Fig 2: Cable & Retainer
    GM2007272Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the range selector cable retainer (1) from the lower dash panel.
    6. Fig 3: View Of Range Selector Cable & Steering Column Bracket
    GM1302085Courtesy of GENERAL MOTORS CORP.
  6. Complete the following in order to disconnect the range selector cable (4) from the transmission range selector lever ball stud (1).
    1. Insert a flat bladed tool between the range selector cable end (2) and the range selector lever.
    2. Pry the range selector cable end (2) away from the range selector lever.
  7. Remove the retainer (3) from the range selector cable (4).
  8. Push the range selector cable locking tabs inward toward each other to release from the steering column bracket (5).
  9. Remove the range selector cable (4) from the vehicle.
scientia non olet · About LEMON Manuals