LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 285 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement (5.3L) >> Cable Installation - Transaxle End

Cable Installation - Transaxle End

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. NOTE: Ensure the range selector cable is routed exactly as originally positioned in the vehicle to avoid coming into contact with potential hazards such as hot, sharp, and moving objects.
    Fig 1: View Of Cable And Mounting
    GM1900891Courtesy of GENERAL MOTORS CORP.
  2. Install the range selector cable (2) to the range selector cable bracket. Ensure the range selector cable retaining tabs fully engage the range selector cable bracket.
  3. Install the retainer (1) to the range selector cable (2).
  4. Connect the range selector cable end (3) to the transaxle range switch lever.
    5. Fig 2: Heat Shield And Bolts
    GM1900888Courtesy of GENERAL MOTORS CORP.
  5. Install the heat shield (2).
    6. CAUTION: Refer to Fastener Caution .
  6. Install the heat shield bolts (1) and tighten to 10 N.m (89 lb in).
    7. Fig 3: Identifying Cable And Mounting
    GM2007273Courtesy of GENERAL MOTORS CORP.

  7. Install the range selector cable retainers (2) to the frame.

scientia non olet · About LEMON Manuals