LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 285 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Manual Shift Detent Lever with Shaft Position Switch Assembly
    GM2035543Courtesy of GENERAL MOTORS CORP.
  1. Inspect the following items:
    • Manual shaft (84) for damage or burrs
    • Parking lock actuator assembly (85) for damage
    • Manual shift detent lever with shaft position switch assembly (88) for damage or cracks
    • Manual valve link (89) for damage
    • Manual shift detent lever pin (92) discard - Do NOT reuse.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the following items:
    • Manual shift detent lever with shaft position switch assembly (88)
    • Parking lock actuator assembly (85)
    • Manual shaft (84) (model dependent)
    • NEW manual shift detent lever pin (92)
    • Manual valve link (89)

      Tighten the nut to 31 N.m (23 lb ft).

  3. Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
scientia non olet · About LEMON Manuals