LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 285 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pressure Test Plug
    GM1302097Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Component Fastener Tightening Caution .
  1. Install an oil pressure test plug and tighten to 8 N.m (71 lb in).
  2. Check the transmission fluid level, fill if necessary. Refer to Transmission Fluid Check .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals