Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Canyon and 2009 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspection Areas On Reverse Input Clutch Housing & Drum Assembly

Courtesy of GENERAL MOTORS CORP.

Inspect the reverse input clutch housing and drum assembly for the following conditions:
- Damaged or worn bushings
- Surface finish on the hub and outer housing - check band surface for flatness
- Leak at the weld
- Heat distortion
- Rolled or distorted retaining ring groove

Fig 2: Identifying Reverse Input Clutch Front Bushing

Courtesy of GENERAL MOTORS CORP.

Using the J 25019-16 which is part of J 25019: bushing service set with the J 7004-A: remover, remove the reverse input clutch front bushing (603).

Fig 3: Locating Reverse Input Clutch Rear Bushing

Courtesy of GENERAL MOTORS CORP.

Using the J 25019-4 which is part of J 25019: bushing service set with the J 8092: driver handle, remove the reverse input clutch rear bushing (606).