LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Luxury, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Vent Hose Replacement (2WD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Transmission Vent Hose Retainer At Transmission Support
    GM2007888Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make a note of the hose routing in order to aid during reassembly.
  2. Disconnect the transmission vent hose retainer (1) from the transmission support.
    3. Fig 2: Transmission Vent Hose Retainer At Tail Housing Bracket
    GM2007886Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the transmission vent hose retainer (1) from the transmission tail housing bracket.
    4. Fig 3: Transmission Vent Hose Retainer At Transmission Housing
    GM2007884Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the transmission vent hose retainer (1) from the transmission housing.
  5. Remove the transmission vent hose (2) from the vent pipe.
scientia non olet · About LEMON Manuals